Hi,
A new water heater was installed by ORA family.

NEW WATER HEATER INSTRUCTIONS

1. Need to bring your own 5 gal propane tank.
2. Hook the propane tank up under bathrooms near the water turn on. Turn on propane valve.
3. Go to generator shed. Plug in generator. Turn on generator.
4. Then water heater is on.
5. Heater Temperature: You must regulate the temperature of the water heater directly on the water
heater. You cannot turn the valves in the shower or washer to mix hot/cold to get the temperature you
want. Turn the knob on the heater for heat temperature you desire. Do not mix hot and cold. Just turn
up or down on water heater to get to the temperature you want. Also, flushing toilet or sink will cause
loss of heat and pressure for a minute or so.

Thanks all. It you have questions contact Robert or Clint.

Note from Robert:
        First of all, there is no electricity from the generator needed.
The heater is totally self contained.  It will need 2 d-cell batteries
(which I have for this year) and they should last the whole year long.  When
the water is turned on, the gas heater ignites using the d-cell batteries
and heats the water as it runs through the coils. 
        Second of all, the water that comes in seems to be very cold up
there, so the hottest I could get it with all of the problems I had with our
water pressure last year was about 104 degrees. If it does
get too hot, you can add cold water at the local tap just like at home.
Adjusting either the flow of the water or the temperature at the heating
unit, while it can be done, will probably not work well. 

Hope this makes things more straight forward and I will be glad to
demonstrate or etc. in the spring.

Have a great day,
Robert